ABS and Rubber Hood Weatherstrip for Pre-Juniper Model Y
Add a shaped barrier at the rear underside edge of the hood, near the windshield, to help limit rainwater, leaves and loose debris passing through that gap. Three ABS support sections join together and hold a long rubber sealing strip. Built-in clips and pre-applied double-sided tape attach the assembly to the matching hood edge of the original-design Model Y.
- Double-Channel Seal
- ABS and Rubber
- Clips and Tape
- Pre-Juniper Model Y
- Black Finish
Hauptmerkmale
-
Three-Section Support
Joined ABS sections follow the rear hood edge
-
Flexible Sealing Edge
A long rubber strip seats into the support channel
-
Clip Alignment
Built-in clips locate the support at the matching hood edge
-
Pre-Applied Tape
Double-sided tape bonds the aligned support
-
Black Finish
A discreet strip along the rear underside of the hood
-
Pre-Juniper Model Y
For the original body design, including the legacy 2020–2025 range
Highlights
Rear Hood-Edge Placement
The strip follows the rear underside of the hood near the windshield, adding a barrier at that gap.
Joined ABS Support
Three molded sections connect into a curved support.
Rubber Sealing Edge
Seat the long rubber strip evenly in the support channel.
Clips and Adhesive
Trial-fit with the adhesive liners on. Once the clips and profile align, remove the liners and apply even pressure.
Kompatibilität
| Modell | Years / Version | Hinweise |
|---|---|---|
| Tesla Model Y original design | 2020–2025, pre-Juniper | Original body design only. Excludes refreshed Model Y Juniper and Model 3. |
Fits the original-design Model Y only. Does not fit Model Y Juniper.
Technische Daten
| Produkttyp | Double-channel hood weatherstrip kit |
|---|---|
| Compatible Models | Tesla Model Y original design, pre-Juniper; legacy 2020–2025 range |
| Position / Location | Rear underside edge of the hood, near the windshield |
| Material | ABS support with a rubber sealing strip |
| Farbe | Schwarz |
| Menge | 1 kit with 3 ABS sections and 1 rubber strip |
| Installation Type | Built-in clips and pre-applied double-sided tape |
| Lieferumfang | 3 ABS support sections, 1 rubber sealing strip and installation instructions |
| Versandgewicht | 580 g (1.28 lb) |
What's in the Box
- 3×ABS support sections
- 1×Rubber sealing strip
- Installation instructions
Installation
- Clean and dry the hood-edge contact surfaces, and trial-fit the sections with the adhesive liners on.
- Connect all three ABS sections, and seat the rubber strip evenly along the channel.
- Peel the liners, align the clips and press evenly.
Gut zu wissen
Achtung
- Not for the Model Y Juniper or Model 3.
- It does not replace the vehicle's original seals, and an existing water leak needs diagnosis and repair.
Pflege
- Clear debris from the hood-edge area, original drains and ventilation paths.
FAQ
Does it fit a 2025 Model Y?
It fits a 2025 Model Y of the original pre-Juniper design. It does not fit the refreshed Juniper.
What is included?
Three ABS support sections, one rubber sealing strip and installation instructions.
How is the strip attached?
Built-in clips and pre-applied double-sided tape attach the support. Trial-fit with the adhesive liners on.
Does it seal the whole frunk?
It adds a barrier at the rear hood gap. Keep the original seals and drainage in working order; an existing leak needs diagnosis and repair.
English 
German 
Spanish 