Ver.1 Carbon-Face Replacement Hood for Model 3
This Ver.1 hood uses a vacuum carbon-fiber upper surface with a clear coating and a fiberglass structure with matte-black primer underneath. Three single-sided finish options are available: woven gloss, woven matte and forged gloss. The photos show the sculpted panel on the original Model 3 body.
- Replacement Hood
- Single-Sided Carbon Face
- Fiberglass Structure
- Three Finishes
Key Features
-
Ver.1 Hood Shape
The product photos show a sculpted replacement hood on the original Model 3 body design.
-
Carbon Upper Surface
The upper face uses vacuum carbon fiber with a clear coating specified for UV protection.
-
Fiberglass Structure
The listing specifies fiberglass with matte-black primer as part of the single-sided construction.
-
Three Finish Choices
Choose woven carbon with gloss, woven carbon with matte, or forged carbon with gloss.
-
Single-Sided Finish
The carbon face is on the top, with a primed underside rather than carbon finishing on both sides.
Highlights
Sculpted Ver.1 Profile
The installed view shows the hood’s shaped center section and side contours on the original Model 3 body. Other exterior parts on the display vehicle are separate from this hood selection.
Upper Carbon Face and Primed Underside
The upper surface uses carbon fiber with a clear coating specified for UV protection. The underside has matte-black primer, with fiberglass included in the single-sided construction.
Choose the Finish
Woven Carbon-Gloss-Single-sided, Woven Carbon-Matte -Single-sided and Forged Carbon-Gloss-Single-sided are the three available purchasing options.
Mounting and Latch Alignment
The hood attaches at the original mounting interfaces, support hardware and latch.
Compatibility
| Model | Years / Version | Notes |
|---|---|---|
| Model 3 | Original body design. |
Fits the original Model 3 body shape shown in the installed photos. Does not fit Highland or later revised body designs.
Specifications
| Product Type | Ver.1 replacement hood panel |
|---|---|
| Compatible Models | Original Model 3 body design |
| Position / Location | Front hood / front-trunk lid |
| Material | Vacuum carbon-fiber upper surface; fiberglass structure with matte-black primer underneath |
| Surface Finish | Woven Carbon-Gloss-Single-sided / Woven Carbon-Matte -Single-sided / Forged Carbon-Gloss-Single-sided |
| Pattern / Weave | Woven or forged-carbon appearance, as selected |
| Installation Type | Hood-panel replacement with mounting and latch alignment |
Installation
- Follow the manufacturer’s fitting and reinforcement requirements.
- Support the panel during removal and dry-fitting. Set panel gaps, flush alignment and clearance through the full opening range without stressing or forcing the laminate.
- Use the manufacturer-specified attachment method and fastener settings.
Good to Know
Caution
- Fits the original Model 3 body version only. Does not fit Highland or other revised body designs.
- Use the hood manufacturer’s composite-panel instructions for attachment, reinforcement and fastener settings. Factory metal-hood torque values are not automatically suitable for this replacement panel.
Care
- Use a soft cloth and finish-compatible vehicle-cleaning products. Avoid abrasives or aggressive polishing, especially on the matte option.
FAQ
Is the whole hood finished in carbon fiber?
It is a single-sided construction: a carbon-fiber upper face with clear coating, and fiberglass with matte-black primer underneath.
Which finishes can I choose?
The three options are woven gloss, woven matte and forged gloss, each named Single-sided.
Are the other body-kit parts in the photos included?
The selected product is the Ver.1 hood. The display vehicle’s other exterior parts are separate selections.
Is a weight saving specified?
Choose this panel for its stated construction and finish. A specific weight saving is not provided.
English 
German 
Spanish 