Real Carbon Fiber for the Highland Rear End
A real-carbon rear diffuser in a 3K twill weave for the non-Performance Model 3 Highland (2024+). It replaces the rear valance with a finned outline and the specified factory-clip and screw fitting method. Available in glossy or matte carbon fiber.
- Real Carbon Fiber
- 3K Twill Weave
- Glossy or Matte
- Replacement Valance
Key Features
-
Real Carbon Fiber
Genuine exposed carbon fiber in a 3K twill weave, not ABS or a vinyl overlay
-
Two Finishes
Choose glossy or matte carbon fiber
-
Highland Bumper Version
Made for the listed non-Performance Model 3 Highland rear valance
-
Replacement Valance
The supplied design uses tabs and fixing points for the original rear bumper
-
Factory-Fixing Installation
The specified fitting method reuses factory clips and screws rather than adhesive tape
-
Lower Fins
Pronounced fins create the rear profile and extend below the original bumper line
Highlights
Finned Rear Profile
The installed view shows the lower fins beneath the rear bumper.
Shaped Replacement Panel
The exposed-carbon panel replaces the original rear valance for the listed non-Performance Highland bumper.
Mounting Tabs
The close-up shows the tabs along the mounting edge.
Carbon Weave Detail
The close-up shows the weave and center-section design. Glossy and matte are selectable finishes; these product views show the glossy appearance.
Compatibility
| Model | Years / Version | Notes |
|---|---|---|
| Model 3 Highland | 2024+ | Not compatible with Highland Performance |
Fits non-Performance Model 3 Highland 2024+. Does not fit the 2017–2023 Model 3 or Model 3 Highland Performance.
Specifications
| Product Type | Real carbon fiber rear diffuser |
|---|---|
| Compatible Models | Model 3 Highland (2024+); not for Model 3 (2017–2023) or Highland Performance |
| Position / Location | Rear bumper, replaces the factory rear valance |
| Material | Real carbon fiber (3K twill weave), not ABS or vinyl overlay |
| Surface Finish | Glossy or matte carbon fiber |
| Pattern / Weave | 3K twill weave |
| Installation Type | Direct replacement using the factory mounting clips and original screws; no drilling or tape |
| Drilling Required | No |
| Shipping Weight | 17.5 kg (38.6 lb) |
Installation
- Remove the original rear valance.
- Fit the diffuser with the specified clips and screws. Do not force mismatched tabs or improvise new holes.
Good to Know
Caution
- Does not fit the 2017–2023 Model 3 or Model 3 Highland Performance.
- The fins extend slightly lower than the factory profile; take care on steep ramps and high speed bumps.
Care
- Clean gently using finish-compatible products; avoid abrasive compounds and high-pressure spray at the edges.
FAQ
Is it real carbon fiber?
Yes. It is made from genuine 3K twill weave carbon fiber, not ABS plastic with a printed pattern or a vinyl overlay.
How is it installed?
It replaces the original valance using factory clips and screws, without drilling or adhesive tape.
Will ground clearance be affected?
The diffuser matches the factory rear bumper profile, but the fins extend slightly lower. Take care on steep ramps or high speed bumps.
English 
German 
Spanish 