{"id":30098,"date":"2026-10-04T22:58:47","date_gmt":"2026-10-05T06:58:47","guid":{"rendered":"https:\/\/tesvx.com\/?post_type=product&p=30098"},"modified":"2026-10-04T23:11:06","modified_gmt":"2026-10-05T07:11:06","slug":"tesla-jack-pad","status":"publish","type":"product","link":"https:\/\/tesvx.com\/de\/product\/tesla-jack-pad\/","title":{"rendered":"4-Piece Rubber Jack Pad Adapters with Zippered Storage Case for Tesla Model 3 \/ Y \/ S \/ X"},"content":{"rendered":"
\n
\n

Jack Pad Adapter Set with Storage Case<\/h3>\n

A set of four black rubber lift-point adapters with red retention rings and a zippered storage case. The molded post and broad contact disc are intended for matching designated body lifting points on Model 3, Model Y, Model S and Model X. Available in 25 mm and 20 mm sizes.<\/p>\n

    \n
  • 4 Pads<\/li>\n
  • Aufbewahrungsetui<\/li>\n
  • Rubber Contact<\/li>\n
  • 20 mm \/ 25 mm<\/li>\n<\/ul>\n<\/section>\n
    \n

    Hauptmerkmale<\/h4>\n
      \n
    1. \n
      Rubber Contact Disc<\/h5>\n

      A broad rubber base provides the interface between a suitable lifting saddle and the designated vehicle lift point.<\/p>\n<\/li>\n

    2. \n
      Locating Post<\/h5>\n

      The molded post locates in the lift-point opening.<\/p>\n<\/li>\n

    3. \n
      Temporary O-Ring Retention<\/h5>\n

      The red ring helps retain the pad during positioning and is not a lifting lock.<\/p>\n<\/li>\n

    4. \n
      Four-Pad Set<\/h5>\n

      Four separate adapters are supplied for workshop lifting-point setup.<\/p>\n<\/li>\n

    5. \n
      Zippered Storage Case<\/h5>\n

      The included case keeps the pads together between uses.<\/p>\n<\/li>\n

    6. \n
      Two Size Selections<\/h5>\n

      Choose the 25 mm option or the 20 mm option labeled for the Tesla Germany factory.<\/p>\n<\/li>\n<\/ol>\n<\/section>\n

      \n

      Highlights<\/h4>\n
      \"Four
      \n
      Four Pads and Storage Case<\/h5>\n

      Four adapters sit in the zippered case. The separate pad pictured beside it shows the molded post and red retention ring.<\/p>\n<\/figcaption><\/figure>\n

      \"Contact-Surface
      \n
      Contact-Surface Illustration<\/h5>\n

      The rubber disc sits between a compatible lifting saddle and the designated lift point. This illustration shows the contact arrangement.<\/p>\n<\/figcaption><\/figure>\n

      \n
      Choose the Matching Size<\/h5>\n

      The selections are 25 mm and 20 mm (for Tesla Germany Factory).<\/p>\n<\/figcaption><\/figure>\n

      \n
      Vehicle Lifting Preparation<\/h5>\n

      Use designated body lift points and the correct rated equipment. Air-suspension vehicles require Jack Mode before lifting; the charging cable must be disconnected.<\/p>\n<\/figcaption><\/figure>\n<\/section>\n

      \n

      Kompatibilit\u00e4t<\/h4>\n
      \n\n\n\n\n\n\n\n\n
      Modell<\/th>\nYears \/ Version<\/th>\nHinweise<\/th>\n<\/tr>\n<\/thead>\n
      Model 3<\/td>\n<\/td>\nFits the designated body lifting points.<\/td>\n<\/tr>\n
      Model Y<\/td>\n<\/td>\n20 mm option is labeled for Germany-factory vehicles.<\/td>\n<\/tr>\n
      Model S<\/td>\n<\/td>\nFits the designated body lifting points; enable Jack Mode if equipped with air suspension.<\/td>\n<\/tr>\n
      Model X<\/td>\n<\/td>\nFits the designated body lifting points; enable Jack Mode if equipped with air suspension.<\/td>\n<\/tr>\n<\/tbody>\n<\/table>\n<\/div>\n

      The 20 mm size is labeled for Tesla Germany Factory vehicles. No separate Model YL fit is established by this description.<\/p>\n<\/section>\n

      \n

      Technische Daten<\/h4>\n
      \n\n\n\n\n\n\n\n\n\n\n
      Produkttyp<\/th>\nJack pad adapter set with storage case<\/td>\n<\/tr>\n
      Compatible Models<\/th>\nModel 3, Model Y, Model S and Model X with a matching designated body lift-point interface<\/td>\n<\/tr>\n
      Position \/ Location<\/th>\nVehicle-designated body lifting points only<\/td>\n<\/tr>\n
      Material<\/th>\nRubber pads with retention O-rings<\/td>\n<\/tr>\n
      Farbe<\/th>\nBlack pads with red retention rings<\/td>\n<\/tr>\n
      Menge<\/th>\n4 pads and 1 zippered storage case<\/td>\n<\/tr>\n
      Gewicht<\/th>\n720 g (1.59 lb), listed shipping weight for each option<\/td>\n<\/tr>\n
      Size Options<\/th>\n25 mm; 20 mm (for Tesla Germany Factory), as labeled selections<\/td>\n<\/tr>\n<\/tbody>\n<\/table>\n<\/div>\n<\/section>\n
      \n

      What's in the Box<\/h4>\n
        \n
      • 4\u00d7<\/b>Jack pad adapters<\/li>\n
      • 1\u00d7<\/b>Zippered storage case<\/li>\n<\/ul>\n<\/section>\n
        \n

        Installation<\/h4>\n
        \n
        \n
        Difficulty<\/dt>\n
        Advanced<\/dd>\n<\/div>\n
        \n
        Werkzeuge<\/dt>\n
        Correctly rated jack or lift and independent support equipment appropriate to the vehicle<\/dd>\n<\/div>\n<\/dl>\n
          \n
        1. Locate the designated body lift points.<\/li>\n
        2. Disconnect the charging cable. Enable Jack Mode on vehicles equipped with air suspension.<\/li>\n
        3. Place the adapter in the lift-point opening so the rubber contact disc sits between the saddle and the lift point.<\/li>\n
        4. Center the suitable lifting saddle beneath the pad and lift.<\/li>\n<\/ol>\n<\/section>\n
          \n

          Gut zu wissen<\/h4>\n
          \n
          \n
          Achtung<\/span><\/h5>\n
            \n
          • Use only the vehicle-designated body lifting points; never lift beneath the battery or side rails.<\/li>\n
          • Disconnect the charging cable before lifting. On vehicles with air suspension, enable Jack Mode before lifting.<\/li>\n
          • Use rated lifting equipment on a firm level surface, follow its instructions and engage lift safety locks. Never work beneath a vehicle supported only by a jack; use correctly rated independent supports or a suitable lift.<\/li>\n
          • The O-ring provides temporary positioning retention, not a load lock. Do not force a mismatched post, drill the lift point or use a damaged pad.<\/li>\n<\/ul>\n<\/div>\n
            \n
            Pflege<\/span><\/h5>\n
              \n
            • Inspect rubber and retention rings before each use; replace damaged or deformed pads.<\/li>\n
            • Clean off dirt and debris, then dry before storing the set in its case.<\/li>\n
            • Remove the pads after use. The retention rings are for temporary positioning, not permanent installation.<\/li>\n<\/ul>\n<\/div>\n<\/div>\n<\/section>\n
              \n

              FAQ<\/h4>\n
              \nWhich size should I select?<\/summary>\n

              Choose between the labeled 25 mm option and 20 mm (for Tesla Germany Factory) option. The 20 mm size is labeled for Tesla Germany Factory vehicles.<\/p>\n<\/details>\n

              \nWhat is included?<\/summary>\n

              Four jack pad adapters and one zippered storage case.<\/p>\n<\/details>\n

              \nDoes the O-ring lock the vehicle to the jack?<\/summary>\n

              No. It provides temporary retention while positioning the adapter. It is not a load lock or a substitute for correct lifting contact and support equipment.<\/p>\n<\/details>\n

              \nDo air-suspension vehicles need preparation?<\/summary>\n

              Yes. Enable Jack Mode before lifting if equipped with air suspension. Disconnect the charging cable on all vehicles before lifting.<\/p>\n<\/details>\n

              \nCan I work underneath with only a jack supporting the car?<\/summary>\n

              No. A jack alone is not a support for working underneath.<\/p>\n<\/details>\n<\/section>\n<\/div>","protected":false},"excerpt":{"rendered":"

              Jack Pad Adapter Set with Storage Case A set of four black rubber lift-point adapters with red retention rings and a zippered storage case. The molded post and broad contact disc are intended for matching designated body lifting points on Model 3, Model Y, Model S and Model X. Available in 25 mm and 20 […]<\/p>\n","protected":false},"featured_media":18053,"comment_status":"open","ping_status":"closed","template":"","meta":{"_gspb_post_css":""},"product_brand":[127],"product_cat":[701],"product_tag":[260,261,262,263,264,265,266,267,268,270,271,285,662,276,277,328,363,278,280,594,663,504,340],"class_list":["post-30098","product","type-product","status-publish","has-post-thumbnail","product_brand-autoboss","product_cat-tesvx-other","product_tag-260","product_tag-261","product_tag-262","product_tag-263","product_tag-264","product_tag-265","product_tag-266","product_tag-267","product_tag-268","product_tag-270","product_tag-accessories","product_tag-exterior","product_tag-jack-pad","product_tag-model-3","product_tag-model-3-highland","product_tag-model-s","product_tag-model-x","product_tag-model-y","product_tag-model-yl","product_tag-tag__hot_must-have","product_tag-tesla-must-have-accessory","product_tag-tools","product_tag-wheel-accessories","first","instock","shipping-taxable","purchasable","product-type-variable","has-default-attributes"],"_links":{"self":[{"href":"https:\/\/tesvx.com\/de\/wp-json\/wp\/v2\/product\/30098","targetHints":{"allow":["GET"]}}],"collection":[{"href":"https:\/\/tesvx.com\/de\/wp-json\/wp\/v2\/product"}],"about":[{"href":"https:\/\/tesvx.com\/de\/wp-json\/wp\/v2\/types\/product"}],"replies":[{"embeddable":true,"href":"https:\/\/tesvx.com\/de\/wp-json\/wp\/v2\/comments?post=30098"}],"wp:featuredmedia":[{"embeddable":true,"href":"https:\/\/tesvx.com\/de\/wp-json\/wp\/v2\/media\/18053"}],"wp:attachment":[{"href":"https:\/\/tesvx.com\/de\/wp-json\/wp\/v2\/media?parent=30098"}],"wp:term":[{"taxonomy":"product_brand","embeddable":true,"href":"https:\/\/tesvx.com\/de\/wp-json\/wp\/v2\/product_brand?post=30098"},{"taxonomy":"product_cat","embeddable":true,"href":"https:\/\/tesvx.com\/de\/wp-json\/wp\/v2\/product_cat?post=30098"},{"taxonomy":"product_tag","embeddable":true,"href":"https:\/\/tesvx.com\/de\/wp-json\/wp\/v2\/product_tag?post=30098"}],"curies":[{"name":"wp","href":"https:\/\/api.w.org\/{rel}","templated":true}]}}